If you have been reading about stationary phase and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2026-01-10. Numbers and descriptions here follow the published literature rather than marketing material.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample by passing them through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in how analytes partition between the mobile phase and the stationary phase cause them to exit the column at different times. Detection then records a signal proportional to the amount of each separated substance. The resulting chromatogram provides retention times and peak areas for identification and quantification.
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
Routine HPLC testing compares a sample result with a calibration curve prepared from known reference standards. Peak area or peak height is plotted against concentration, and the curve is used to estimate unknown amounts. Retention time supports tentative identification when compared with a standard, though mass spectrometry or another confirmatory method may be needed for definitive identification. Pre-run checks verify repeatability, resolution, and peak symmetry before sample analysis. Limits of detection and quantification describe the smallest amounts that can be reliably observed or measured. Sample preparation, filtration, and degassing help prevent column damage and inconsistent results.
| Property | Value | Notes |
|---|---|---|
| Separation principle | Differential partitioning | Analytes distribute between mobile and stationary phases. |
| Mobile phase | Liquid solvent mixture | Composition controls retention and selectivity. |
| Stationary phase | Packed column particles | Often chemically bonded silica. |
| Typical detector | UV-Vis or photodiode array | Mass spectrometry is also common. |
| Common synonym | High-performance liquid chromatography | Abbreviated as HPLC. |
Quality control for HPLC testing combines scheduled checks, documented procedures, and review of results. Before sample analysis, system suitability testing confirms that the instrument, column, and method meet predefined criteria. Common criteria include resolution between critical peaks, retention time precision, peak tailing, and theoretical plate count. Failure triggers investigation before results are reported. Records link raw data, calculations, instrument logs, and analyst identity to each batch, supporting audits and repeat analysis.
Method validation evaluates accuracy, precision, specificity, linearity, range, detection limit, quantitation limit, and robustness. Regulatory guidance for pharmaceuticals, foods, and environmental testing defines expected documentation and acceptance criteria. Verification confirms that a validated method works in a specific laboratory with its own instruments and reagents. Calibration curves use reference standards with known purity and traceability, while measurement uncertainty is estimated from validation data, control charts, and collaborative studies. The scope of validation depends on the method's intended use.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
In 1912, Alfred Eric Frank, then working on diabetes mellitus in the department of Oskar Minkowski in Breslau, reported a specific link to the pituitary gland upon observing a case of a man who had survived after shooting himself in the temple. Morris Simmonds drew the same connection in 1913. Thereafter, numerous reports documented cases of diabetes insipidus associated with pituitary lesions, steadily accumulating evidence favouring the hypothesized connection. George Oliver and Edward Albert Schafer were among the first researchers to document its endocrine functions. In the first two decades of the 20th century, however, a number of conflicting reports on the diuretic versus anti-diuretic properties of the pituitary extract caused confusion in the field. A general agreement was reached that some of the results that reported diuresis was due to increased pressure and blood flow to the kidney, while the posterior pituitary extract had an antidiurectic effect. By the 1920s, accumulated findings defined diabetes insipidus as a disorder of the pituitary. The main question now became whether the cause of diabetes insipidus lay in the pituitary gland or the hypothalamus, given their intimate connection. In 1920, Jean Camus and Gustave Roussy summarized a number of years of research, reporting that they had produced polyuria in dogs by puncturing the hypothalamus while leaving the pituitary intact. These results were later replicated by many others.
=== Levels === Prior to puberty in humans, DHEA and DHEA-S levels elevate upon differentiation of the zona reticularis of the adrenal cortex. Peak levels of DHEA and DHEA-S are observed around age 20, which is followed by an age-dependent decline throughout life eventually back to prepubertal concentrations. Plasma levels of DHEA in adult men are 10 to 25 nM, in premenopausal women are 5 to 30 nM, and in postmenopausal women are 2 to 20 nM. Conversely, DHEA-S levels are an order of magnitude higher at 1–10 μM. Levels of DHEA and DHEA-S decline to the lower nanomolar and micromolar ranges in men and women aged 60 to 80 years. DHEA levels are as follows:
=== Classification of antivirals based on target === Classifying antivirals based on their target of action, the protein or process that they interact with, serves to create two broad categories of antivirals: direct-acting antivirals (DAAs) and host-targeting antivirals (HTAs).
For example in the E1 transition, unless Δ l = ± 1, Δ ml = 0 or ± 1, Δ ms = 0, and Δ n = any integer, the equation above will yield a value equal to zero and the transition would be known as a “forbidden transition”. For example, this would occur for certain cases like when Δ l = 2. In this case, the transition would not be allowed and therefore would be much weaker than an allowed transition. These specific values for the changes in quantum numbers are known as the selection rules for the allowed transitions and are shown for common transitions in the table below:
Sources: en.wikipedia.org
=== Correcting for GPS signal errors === In the 1990s, NASA scientists at JPL developed software capable of correcting for GPS signal errors, enabling accuracy within inches; it is called Real-Time GIPSY (RTG). John Deere licensed the software and used it to develop self-driving farm equipment. As of 2016, as nearly 70% of North American farmland is cultivated by self-driving tractors, which rely on RTG that was developed at NASA. Another user of RTG is Comtech Telecommunications, which is a major provider of location-based services. This technology is used in cell phones so that 9-1-1 emergency callers can be located.
Singapore, for instance, operates an Exit Permit scheme to enforce the national service obligations of its male citizens and permanent residents. These restrictions vary according to age and status. South Korea and Taiwan have similar policies. India, on the other hand, requires citizens who have not met certain educational requirements (and thus may be targeted by human traffickers or be coerced into modern slavery) to apply for approval before leaving the country and endorses their passports with "Emigration Check Required". Nepal similarly requires citizens emigrating to America on an H-1B visa to present an exit permit issued by the Ministry of Labour. This document, called a work permit, must be presented to immigration to leave the country. In a bid to increase protection for the large amount of Indian, Bangladeshi, Chinese, and Nepali citizens smuggled through Indian airports to the Middle East as underpaid labourers, many Indian airline companies require travellers to obtain an 'OK to Board' confirmation sent directly from visa authorities in certain GCC countries directly to the airline and will bar anyone who has not obtained this endorsement from clearing exit immigration. Eritrea requires the vast majority of its citizens to obtain special authorization to leave the country or even to travel within it.
=== Quality guidelines and standards === For occupational exposure, there are standards, which cover a wide range of chemicals, and applied to healthy adults who are exposed over time at workplaces (usually industrial environments).These are published by organizations such as Occupational Safety and Health Administration (OSHA), the National Institute for Occupational Safety and Health (NIOSH), the UK Health and Safety Executive (HSE). There is no consensus globally about indoor air quality standards, or health-based guidelines. However, there are regulations from some individual countries and from health organizations. For example, the World Health Organization (WHO) has published health-based global air quality guidelines for the general population that are applicable both to outdoor and indoor air, as well as the WHO IAQ guidelines for selected compounds, whereas the UK Health Security Agency published IAQ guidelines for selected VOCs. The Scientific and Technical Committee (STC34) of the International Society of Indoor Air Quality and Climate (ISIAQ) created an open database that collects indoor environmental quality guidelines worldwide. The database is focused on indoor air quality (IAQ), but is currently extended to include standards, regulations, and guidelines related to ventilation, comfort, acoustics, and lighting.
Sources: en.wikipedia.org
A position frequency matrix (PFM) records the position-dependent frequency of each residue or nucleotide. PFMs can be experimentally determined from SELEX experiments or computationally discovered by tools such as MEME using hidden Markov models. A position weight matrix (PWM) contains log odds weights for computing a match score. A cutoff is needed to specify whether an input sequence matches the motif or not. PWMs are calculated from PFMs. PWMs are also known as PSSMs. An example of a PFM from the TRANSFAC database for the transcription factor AP-1:
In autumn 1981 he visited Liverpool again, this time with a thirty-strong task force of representatives of local employers and civil servants (unusually for the time, drawn from different departments – DOE, DTI and Employment, but not the Home Office this time – Heseltine had been pushing for greater cooperation between departments since the setting up of the European Space Agency in 1973). For the next fifteen months he visited Liverpool for a day almost every week, refusing police protection and often driving himself, persuading business and local government to work together. Colette Bowe, a DTI official who was deputy director of the task force, recorded that Heseltine was the most effective minister she had ever seen at getting the official machine to do his bidding through a mixture of charm and tough questions.
This species is maroon to pink, with the opening of the barrel pale white. Specimens are often found emerging from an apparent common base. In the intertidal zones, this species ranges from 10 to 20 cm in diameter and are about 10 to 20 cm tall. A bioactive peptide consisting of 13 amino acids, KENPVLSLVNGMF, has been identified from this species. The peptide was selectively toxic to human cervical cancer cells (HeLa), but non-toxic to non-cancerous, human embryonic kidney cell line (HEK 293 cells).
== Causes == Blistering in Bart syndrome represents a form of epidermolysis bullosa caused by ultrastructural abnormalities in the anchoring fibrils. Genetic linkage of the inheritance of the disease points to the region of chromosome 3 near the collagen, type VII, alpha 1 gene (COL7A1).
Sources: en.wikipedia.org
HPLC separates and detects individual compounds in a liquid sample, producing peaks at characteristic retention times. Peak area or height can be used to estimate concentration when calibrated with known standards. It does not identify unknown compounds with certainty unless additional detectors or reference materials are used.
Pressure drives the liquid mobile phase through a column packed with small particles. Without pressure, flow would be very slow or stop because the packed bed resists liquid movement. Modern pumps maintain a steady flow despite the resistance.
A chromatogram is a plot of detector signal against time after sample injection. Each peak represents a compound or group of compounds eluting from the column. Retention time and peak area are the main measurements read from the plot.
HPLC testing measures the presence and amount of one or more compounds in a liquid sample. It separates mixture components and records detector responses as peaks, which are compared with reference standards. Results are usually reported as concentrations or relative percentages.