The short version of retention time fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-07-23. Anything still debated is marked as such rather than presented as settled.
Developing an HPLC test begins with defining the analytes, matrix, and required reporting limits. Chemists select a separation mode, column chemistry, mobile phase composition, flow rate, and detection wavelength or mass transition. Experiments then adjust these variables to achieve adequate retention, resolution, and peak shape. System suitability tests confirm that the instrument and method perform consistently before sample analysis. Without suitable resolution, quantitative results may be unreliable. Preliminary runs often use scouting gradients to locate retention windows.
Validation establishes that a method is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantification, robustness, and stability of standards and samples. Acceptance criteria are defined in advance, and results are documented in a validation report. Regulatory guidance for pharmaceuticals, foods, and environmental testing differs, so the applicable framework must be identified. Ongoing verification uses control samples and trend charts after validation. Method transfer to another laboratory may require partial revalidation.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
| Property | Value | Notes |
|---|---|---|
| Accuracy | Closeness to true value | Often assessed by recovery of spiked samples |
| Precision | Agreement among repeated measurements | Often reported as relative standard deviation |
| Specificity | Ability to measure analyte without interference | Must separate analyte from impurities and matrix |
| Linearity | Proportional detector response | Evaluated across a defined concentration range |
| Robustness | Resistance to small method changes | Tests flow rate, pH, temperature, and mobile phase composition |
Separation modes differ by the chemistry of the stationary phase and the composition of the mobile phase. Reversed-phase testing uses a nonpolar column and polar solvents, making it common for pharmaceutical, environmental, and food analytes. Normal-phase testing uses a polar column and nonpolar solvents for compounds that are poorly retained in reversed-phase systems. Ion-exchange and ion-pair methods separate charged species, while size-exclusion methods sort molecules by hydrodynamic volume. Gradient elution changes solvent strength over time to resolve complex mixtures, and isocratic elution holds solvent composition constant for simpler assays.
Key performance measures include retention time, peak area, peak height, resolution, tailing factor, and plate count. Retention time helps identify a peak under fixed conditions, but confirmation often requires a second method or detector. Peak area and height relate to concentration through calibration curves, which may be linear or nonlinear depending on the detector response. Resolution describes separation between adjacent peaks, while tailing factor and plate count describe peak shape and column efficiency. Performance checks verify these values before and during a run to confirm that the instrument is performing within limits.
=== Gastrointestinal health === AM function can be compared to another peptide called pro-adrenomedullin N-terminal 20 peptide (PAMP), which both originate from a common precursor leading to angiogenesis, vasodilation, and anti-inflammatory processes. These two peptides are expressed in the gastrointestinal (GI) tract at a mass level, serving as GI hormones controlling processes like insulin secretion and gastric emptying. Past studies reveal that AM and PAMP also impact gut microbiome composition by fostering the development of beneficial bacteria (i.e., Bifidobacterium and Lactobacillus) and diminishing detrimental microbes.
==== Atypical μ-opioid receptor agonist ==== In 2014, tianeptine was found to be a μ-opioid receptor (MOR) full agonist using human proteins. It was also found to act as a full agonist of the δ-opioid receptor (DOR), although with approximately 200-fold lower potency. The same researchers subsequently found that the MOR is required for the acute and chronic antidepressant-like behavioral effects of tianeptine in mice and that its primary metabolite had similar activity as a MOR agonist but with a much longer elimination half-life. Moreover, in mice, although tianeptine produced other opioid-like behavioral effects such as analgesia and reward, it did not result in tolerance or withdrawal. The authors suggested that tianeptine may be acting as a biased agonist of the MOR and that this may be responsible for its atypical profile as a MOR agonist. However, there are reports that suggest that withdrawal effects resembling those of other typical opioid drugs (including but not limited to depression, insomnia, and cold/flu-like symptoms) do manifest following prolonged use at dosages far beyond the medical range. In addition to its therapeutic effects, activation of the MOR is likely to also be responsible for the abuse potential of tianeptine at high doses that are well above the normal therapeutic range and efficacy threshold. In rats, when co-administered with morphine, tianeptine prevents morphine-induced respiratory depression without impairing analgesia.
For many years, exobiologists have proposed the existence of a shadow biosphere, a postulated microbial biosphere of Earth that uses radically different biochemical and molecular processes than currently known life. One of the proposals was the existence of lifeforms that use arsenic instead of phosphorus in DNA. A report in 2010 of the possibility in the bacterium GFAJ-1 was announced, though the research was disputed, and evidence suggests the bacterium actively prevents the incorporation of arsenic into the DNA backbone and other biomolecules.
Sources: en.wikipedia.org
For larger-scale cider production, ciders from vats produced from different varieties of apple may be blended to accord with market taste. If the cider is to be bottled, usually some extra sugar is added for sparkle. Higher quality ciders can be made using the champagne method, but this is expensive in time and money and requires special corks, bottles, and other equipment. Some home brewers use beer bottles, which work perfectly well, and are inexpensive. This allows the cider to become naturally carbonated.
A phase III clinical trial of bicalutamide in combination with an ethinylestradiol-containing combined oral contraceptive for the treatment of severe hirsutism in women with PCOS was completed in Italy in 2017 under supervision of the Italian Agency for Drugs (AIFA). Antiandrogens have been suggested for treating COVID-19 in men and as of May 2020 high-dose bicalutamide is in a phase II clinical trial for this purpose.
Trading with the Enemy Act of 1917 Foreign Assistance Act of 1961 International Emergency Economic Powers Act of 1977 Export Administration Act of 1979 Several laws specifically prohibit trade with certain countries:
=== Severe combined immunodeficiency === Severe combined immunodeficiency (SCID) caused by T-cell deficiency is a disorder that was recently added to newborn screening programs in some regions of the United States. Wisconsin was the first state to add SCID to their mandatory screening panel in 2008, and it was recommended for inclusion in all states' panels in 2010. Since December 2018 all US states perform SCID screening. As the first country in Europe, Norway started nationwide SCID screening January 2018. Identification of infants with SCID is done by detecting T-cell receptor excision circles (TRECs) using real-time polymerase chain reaction (qPCR). TRECs are decreased in infants affected with SCID. SCID has not been added to newborn screening in a wide scale for several reasons. It requires technology that is not currently used in most newborn screening labs, as PCR is not used for any other assays included in screening programs. Follow-up and treatment of affected infants also requires skilled immunologists, which may not be available in all regions. Treatment for SCID is a stem cell transplant, which cannot be done in all centers.
Sources: en.wikipedia.org
System suitability is a set of checks performed before and during a run to confirm that the instrument, column, and method work as expected. Common checks include resolution, tailing factor, theoretical plates, and relative standard deviation of replicate injections. Failure triggers troubleshooting or method adjustment.
Validation demonstrates that a method produces reliable results for a defined purpose. It documents performance limits and acceptance criteria. Regulated industries require validation before routine testing of products or samples.
Retention time shifts can arise from changes in mobile phase composition, pH, temperature, column age, or flow rate. Contamination or worn seals may also alter pressure and delivery. Systematic checks of these factors help identify the cause.
HPLC testing measures the presence and amount of one or more compounds in a liquid sample. It separates mixture components and records detector responses as peaks, which are compared with reference standards. Results are usually reported as concentrations or relative percentages.