If you have been reading about quality control and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-06-30. Where a claim depends on a specific study, the study is described rather than over-claimed.
Practical HPLC testing depends on careful sample preparation and instrument maintenance. Samples may require filtration, dilution, pH adjustment, or extraction to avoid column damage and matrix interference. Mobile phases are degassed and filtered, and columns are equilibrated before injection. Common problems include peak tailing, baseline drift, ghost peaks, carryover, and co-elution of analytes. Documentation of instrument logs, calibration records, and electronic audit trails supports data integrity and traceability. Ongoing training and routine maintenance help reduce variability between analysts and laboratories.
Quality control laboratories use HPLC to check identity, purity, concentration, and stability of raw materials and finished products. A validated method specifies the column, mobile phase, flow rate, detection wavelength, injection volume, and run time. Samples are prepared and compared against reference standards of known concentration. The resulting chromatogram provides quantitative data, such as assay values and impurity levels. This approach is common in pharmaceutical, food, environmental, and industrial testing where consistent measurements are required.
Method validation evaluates accuracy, precision, specificity, linearity, range, detection limit, quantitation limit, and robustness. Regulatory guidance for pharmaceuticals, foods, and environmental testing defines expected documentation and acceptance criteria. Verification confirms that a validated method works in a specific laboratory with its own instruments and reagents. Calibration curves use reference standards with known purity and traceability, while measurement uncertainty is estimated from validation data, control charts, and collaborative studies. The scope of validation depends on the method's intended use.
Routine quality control monitors retention time shifts, baseline noise, system pressure, and peak shape. Trends can reveal column aging, mobile phase preparation errors, detector drift, or sample degradation. Corrective actions may include replacing the column, preparing fresh mobile phase, or recalibrating the detector. Stability testing often uses HPLC to measure parent compound loss and degradation product formation. Open questions remain about how accelerated stability results extrapolate to long-term storage under varied conditions.
| Parameter | Typical acceptance criterion | Notes |
|---|---|---|
| Resolution | ≥ 1.5 | Baseline separation of adjacent peaks |
| Tailing factor | ≤ 2.0 | Peak symmetry measure |
| Theoretical plates | > 2000 | Column efficiency indicator |
| Injection repeatability | ≤ 2% RSD | Relative standard deviation for replicate injections |
| Linearity | r² ≥ 0.995 | Calibration curve over the working range |
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample by passing them through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in how analytes partition between the mobile phase and the stationary phase cause them to exit the column at different times. Detection then records a signal proportional to the amount of each separated substance. The resulting chromatogram provides retention times and peak areas for identification and quantification.
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
Routine HPLC testing compares a sample result with a calibration curve prepared from known reference standards. Peak area or peak height is plotted against concentration, and the curve is used to estimate unknown amounts. Retention time supports tentative identification when compared with a standard, though mass spectrometry or another confirmatory method may be needed for definitive identification. Pre-run checks verify repeatability, resolution, and peak symmetry before sample analysis. Limits of detection and quantification describe the smallest amounts that can be reliably observed or measured. Sample preparation, filtration, and degassing help prevent column damage and inconsistent results.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample. A pump moves a liquid mobile phase through a column packed with a solid stationary phase. Compounds interact differently with both phases and travel at different rates, leaving the column at distinct retention times. A detector records these arrivals as peaks on a chromatogram. The resulting pattern supports identification and quantification of substances in mixtures. Modern instruments use high pressure to force solvent through small particles, which improves speed and resolution compared with older low-pressure liquid chromatography methods.
Separation in HPLC depends on the chemistry of the stationary phase, the composition of the mobile phase, and the physical properties of the column. Reverse-phase separations use a nonpolar stationary phase and a polar mobile phase, and they are common for many organic compounds. Ion-exchange, size-exclusion, and normal-phase modes serve other classes of analytes. Gradient elution changes solvent strength over time, while isocratic elution holds it constant. Flow rate, temperature, particle size, and column length all influence peak shape and resolution. Detection may use ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry, depending on the analyte and the required sensitivity.
The logic of this was that if McCarthyists were accusing so many people of being communist agents, it could only be to divert attention from the real communists. The theme of collusion between international communists and Western rightists would be picked up again by many movies (Goldfinger, A View to a Kill) or television shows (episodes of MacGyver or Airwolf), which would feature an alliance between power-hungry communists attacking the free world from the outside and profit-driven capitalists undermining it for financial gain. The Ugly American by William J. Lederer and Eugene Burdick. Originally published in 1958, this book tells the story of how the US government handled foreign policy very poorly. The main character, Homer Atkins, discovers this sad truth when he is dispatched to the fictitious country of Sarkhan (in Southeast Asia.) One Day in the Life of Ivan Denisovich by Alexander Solzhenitsyn. This acclaimed book, first published in 1962, exposed the horrors of the Russian prison camps during WWII under the Stalinist regime. It is a semi-autobiographical tale about a dutiful soldier who is sent to a Siberian camp, after being falsely accused of treason. Solzhenitsyn received the Nobel Prize in literature. Starship Troopers by Robert A. Heinlein
==== Mycotoxins ==== In April 2014, aflatoxin B1, a known carcinogenic toxin, melamine, and cyanuric acid were all found in various brands of USA pet food imported into Hong Kong. Since 1993, the FDA has confirmed concerns of toxins in feed grade (animal grade) ingredients, yet to date no comprehensive federal regulation exists on mycotoxin testing in feed grade (animal grade) ingredients used to make pet food. In 1997, the Journal of Food Additives and Contaminants established that low levels of various mycotoxins could cause health concerns in pets, and was found in feed grade ingredients. A study published in the Journal of Food Protection in 2001 cited concerns regarding fungi (the source of mycotoxins) in commercial pet foods and warned about the "risk for animal health". In 2006, a study published in the Journal of Agricultural and Food Chemistry confirmed mycotoxins in pet foods around the world and concluded that contamination of mycotoxins in pet foods can lead to chronic effects on the health of pets. In 2007, the International Journal of Food Microbiology published a study that claimed "mycotoxin contamination in pet food poses a serious health threat to pets", and listed them: aflatoxins, ochratoxins, trichothecenes, zearalenone, fumonisins and fusaric acid. A 2008 study published in the Journal of Animal Physiology and Animal Nutrition found high levels of mycotoxins in the raw ingredients used for pet food in Brazil. A 2010 study in the Journal of Mycotoxin Research tested 26 commercial dog foods and found mycotoxins at concerning sub-lethal levels.
US and South African justification for arming UNITA lay partly in the increased supply by the Soviet Union of more sophisticated weapons to FAPLA, as well as the increased number of Cuban troops in Angola, which had rapidly swelled from 25,000 to 31,000 by the end of 1985. While the Lusaka Accords were still in force, the Cuban and Soviet military delegations had urged dos Santos to take advantage of the ceasefire with the SADF to eliminate UNITA. There was a considerable increase in Soviet military assistance to Angola during this period, with the transfer of another billion dollars' worth of arms to FAPLA, including about 200 new T-55 and T-62 tanks. Moscow trained more Angolan pilots and delivered more advanced fighter aircraft to Luanda, particularly Mikoyan-Gurevich MiG-23s. Over a three year period Angola had become the second largest importer of arms on the African continent. FAPLA's arsenal expanded so exponentially that the SADF became convinced that the Soviet-sponsored arms buildup was intended for deployment elsewhere. General Malan gave a speech in which he expressed alarm at the "flood" of Soviet military equipment and its sophisticated nature, claiming that it was much more than needed to cope with the SADF's limited expeditionary forces and UNITA. Malan theorised that "the Russians want to develop a strong, stabilised base in Angola and then use the equipment and personnel positioned there wherever necessary in the subcontinent".
non-coding DNA (ncDNA) Any segment of DNA that does not encode a sequence that may ultimately be transcribed and translated into a protein. In most organisms, only a small fraction of the genome consists of protein-coding DNA, though the proportion varies greatly between species. Some non-coding DNA may still be transcribed into functional non-coding RNA (as with transfer RNAs) or may serve important developmental or regulatory purposes; other regions (as with so-called "junk DNA") appear to have no known biological function.
Sources: en.wikipedia.org
Bard (1933–2024), American chemist known for development of the scanning electrochemical microscope, Wolf Prize in Chemistry Vincenzo Barone (born 1952), Italian chemist working in theoretical and computational chemistry Denise Barthomeuf (1934-2004), French chemist working on zeolites Neil Bartlett (1932–2008), English/Canadian/American chemist known for creating the first noble-gas compound Sir Derek Barton (1918–1998), 1969 Nobel Prize in Chemistry for “contributions to the development of the concept of conformation and its application in chemistry"
The thrifty gene hypothesis (also called the famine hypothesis) states that in some populations the body would be more efficient at retaining fat in times of plenty, thereby endowing greater resistance to starvation in times of food scarcity. This hypothesis, originally advanced in the context of glucose metabolism and insulin resistance, has been discredited by physical anthropologists, physiologists, and the original proponent of the idea himself with respect to that context, although according to its developer it remains "as viable as when [it was] first advanced" in other contexts. In 1995, Jeffrey Friedman, in his residency at the Rockefeller University, together with Rudolph Leibel, Douglas Coleman et al. discovered the protein leptin that the genetically obese mouse lacked. Leptin is produced in the white adipose tissue and signals to the hypothalamus. When leptin levels drop, the body interprets this as a loss of energy, and hunger increases. Mice lacking this protein eat until they are four times their normal size. Leptin, however, plays a different role in diet-induced obesity in rodents and humans. Because adipocytes produce leptin, leptin levels are elevated in the obese. However, hunger remains, and—when leptin levels drop due to weight loss—hunger increases. The drop of leptin is better viewed as a starvation signal than the rise of leptin as a satiety signal. However, elevated leptin in obesity is known as leptin resistance. The changes that occur in the hypothalamus to result in leptin resistance in obesity are currently the focus of obesity research.
Insulin granules are a specific type of granule found in pancreatic beta cells. Insulin granules are secretory granules, which are responsible for the storage and secretion of insulin, a hormone that regulates the concentration of glucose in the bloodstream to maintain homeostasis. The release of insulin by granules is signaled by plasma glucose concentrations and the resultant influx of calcium ions in pancreatic cells, which initiate granule exocytosis. Insulin release is biphastic, as insulin is first released in the primary phase by granules closest to the plasma membrane. In the secondary phase, insulin granules are recruited from reserves deeper in the beta cell for a slower release rate. Insulin granules undergo a significant maturation process. First, precursor proinsulin molecules are synthesized in the endoplasmic reticulum and packaged in the golgi network. Insulin granules bud from the trans golgi network and are further sorted via clathrin-coated vesicle transport. After budding, insulin secretory granules are acidified, activating endoproteases PC1/3 and PC2 to convert proinsulin into insulin. The clatherin coating is released and the insulin secretory granules are transported across the cell via actin filaments and microtubules.
Sources: en.wikipedia.org
Method validation is the documented process of confirming that an HPLC procedure is suitable for its intended use. It evaluates accuracy, precision, specificity, linearity, range, detection limits, and robustness. Validation criteria depend on the regulatory context and the sample type.
System suitability tests are short checks performed before or during an HPLC run to verify instrument and method performance. They often include resolution, tailing factor, theoretical plates, and injection precision. Results must meet predefined limits for sample data to be accepted.
HPLC retention time alone cannot definitively identify an unknown substance. A match with a reference standard under identical conditions provides supporting evidence. Confirmation typically requires mass spectrometry, nuclear magnetic resonance, or another orthogonal technique.
System suitability is typically performed before each batch or according to the validated method and laboratory procedure. Some long runs include periodic checks during analysis. The required frequency depends on regulatory expectations and method performance.