If you have been reading about precision and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2026-08-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
High-performance liquid chromatography is an analytical technique that separates components in a liquid sample by passing them through a packed column under pressure. A pump delivers a mobile phase at a controlled flow rate, and an injector introduces the sample into the stream. Differences in how analytes partition between the mobile phase and the stationary phase cause them to exit the column at different times. Detection then records a signal proportional to the amount of each separated substance. The resulting chromatogram provides retention times and peak areas for identification and quantification.
Instrumentation includes a solvent delivery system, an autosampler, a column oven, and one or more detectors. Reversed-phase columns with chemically modified silica are widely used, but normal-phase, ion-exchange, size-exclusion, and affinity modes exist for specific separations. Detectors may rely on ultraviolet absorbance, fluorescence, refractive index, or mass spectrometry. Column temperature, mobile phase composition, and flow rate are adjusted to improve resolution. System pressure is monitored because rising pressure can indicate column blockage or deteriorating packing.
| Property | Value | Notes |
|---|---|---|
| Separation mode | Reversed-phase | Nonpolar stationary phase with polar mobile phase |
| Typical column particle size | 3–5 µm | Smaller particles improve resolution but raise pressure |
| Typical flow rate | 0.5–2.0 mL/min | Depends on column dimensions and pressure limits |
| Common detection | UV-Vis absorbance | Requires analytes with chromophores |
| Typical run time | 5–30 min | Varies with method, gradient, and sample complexity |
High-performance liquid chromatography testing separates components of a liquid sample by forcing a mobile phase through a packed column. The stationary phase inside the column interacts with analytes to different degrees, so each compound exits at a characteristic retention time. A pump delivers solvent at controlled flow and pressure, while an injector introduces a precise sample volume. Detectors such as ultraviolet-visible, fluorescence, refractive index, or mass spectrometric instruments record the separated bands. The resulting chromatogram provides qualitative and quantitative information about the mixture.
Separation modes differ by the chemistry of the stationary phase and the composition of the mobile phase. Reversed-phase testing uses a nonpolar column and polar solvents, making it common for pharmaceutical, environmental, and food analytes. Normal-phase testing uses a polar column and nonpolar solvents for compounds that are poorly retained in reversed-phase systems. Ion-exchange and ion-pair methods separate charged species, while size-exclusion methods sort molecules by hydrodynamic volume. Gradient elution changes solvent strength over time to resolve complex mixtures, and isocratic elution holds solvent composition constant for simpler assays.
Method validation establishes that an HPLC procedure is suitable for its intended use. Key parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Accuracy measures agreement with a true or accepted value, while precision describes repeatability and intermediate precision. Specificity confirms that the method measures the analyte without interference from impurities, degradants, or excipients. Validation is documented in a protocol and report, and acceptance criteria are set before experiments begin. Regulatory guidance varies by region, but the general principles are widely harmonized.
System suitability testing is performed before and during analytical runs to confirm that the instrument and method are working as expected. Common checks include retention time, peak area, resolution between critical pairs, tailing factor, and theoretical plate count. Results are compared with predefined limits, and a failed check requires investigation before sample results are reported. Quality control samples at low, middle, and high concentrations are injected at intervals to monitor accuracy and precision. Blank injections detect carryover and contamination, while control charts track performance over time.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
Routine HPLC testing depends on controlled reagents, calibrated instruments, and documented procedures. Columns degrade over time, so retention times and peak shapes are monitored for drift. Mobile phases are filtered and degassed to prevent pump damage and detector noise. Reference standards must be traceable and stored under suitable conditions. Data handling systems record injections, calculations, and audit trails. Quality control samples interspersed with unknowns help detect errors during a run.
=== Halides === Protactinium(V) fluoride is a white compound that forms tetragonal crystals, isomorphic to β-UF5. Protactinium(V) chloride forms yellow crystals where protactinium ions are arranged in pentagonal bipyramids and coordinated by 7 other ions. The coordination changes to octahedral in the brown protactinium(V) bromide, but is unknown for protactinium(V) iodide. The protactinium coordination in all its tetrahalides is 8, but the arrangement is square antiprismatic in protactinium(IV) fluoride and dodecahedral in the chloride and bromide. Brown-colored protactinium(III) iodide has been reported, where protactinium ions are 8-coordinated in a bicapped trigonal prismatic arrangement.
Pseudoephedrine is a sympathomimetic drug of the phenethylamine and amphetamine chemical classes. Pseudoephedrine may be used as a nasal/sinus decongestant, as a stimulant, or as a wakefulness-promoting agent. The salts pseudoephedrine hydrochloride and pseudoephedrine sulfate are found in many over-the-counter preparations, either as a single ingredient or (more commonly) in combination with antihistamines, guaifenesin, dextromethorphan, or paracetamol (acetaminophen) or another NSAID (e.g., aspirin or ibuprofen). Pseudoephedrine is also used as a precursor chemical in the illegal production of methamphetamine.
== Mechanism == As previously mentioned, BCKDC's primary function in mammals is to catalyze an irreversible step in the catabolism of branched-chain amino acids. However BCKDC has a relatively broad specificity, also oxidizing 4-methylthio-2-oxobutyrate and 2-oxobutyrate at comparable rates and with similar Km values as for its branched-chain amino acid substrates. The BCKDC will also oxidize pyruvate, but at such a slow rate this side reaction has very little physiological significance. The reaction mechanism is as follows. Please note that any of several branched-chain α-ketoacids could have been used as a starting material; for this example, α-ketoisovalerate was arbitrarily chosen as the BCKDC substrate.
Sources: en.wikipedia.org
=== Temperature: Gas Mark === Gas Mark is a temperature scale, predominantly found on British ovens, that scales linearly with temperature above 135 °C (Gas Mark 1) and scales with the log of Celsius below 135 °C.
=== DSM-5 === Anorexia nervosa is classified under the Feeding and Eating Disorders in the fifth revision of the Diagnostic and Statistical Manual of Mental Disorders (DSM-5). There is no specific BMI cut-off that defines low weight required for the diagnosis of anorexia nervosa. The diagnostic criteria for anorexia nervosa (all of which needing to be met for diagnosis) are:
==== 7 May ==== On 7 May, Khatam al-Anbiya Central Headquarters spokesperson Ebrahim Zolfaghari accused the United States of violating the ceasefire after it targeted two ships at the Strait of Hormuz and strikes in the Hormozgan province including Bandar Khamir, Sirik, and Qeshm Island. He also confirmed that Iran responded by attacking U.S. military vessels east of the waterway and south of Chabahar port. The U.S. Central Command stated that the military carried out "self-defense" strikes against military facilities in response to attacks on the USS Truxtun, USS Rafael Peralta, and USS Mason as the three ships were transiting the Strait of Hormuz into the Gulf of Oman.
Sources: en.wikipedia.org
==== Binding RuBP ==== Carbamylation of the ε-amino group of Lys210 is stabilized by coordination with the Mg2+. This reaction involves binding of the carboxylate termini of Asp203 and Glu204 to the Mg2+ ion. The substrate RuBP binds Mg2+ displacing two of the three aquo ligands.
=== 12 February === Ukrainian data indicated that Russian soldiers were suffering their highest losses since the first week of the war, at 824 soldiers killed per day in February. The UK Ministry of Defence said that the data was "likely accurate". In June and July around 172 Russian soldiers were killed per day. Ukraine was suffering a high attritional rate as well. The Wagner Group captured the village of Krasna Hora north of Bakhmut. The United States embassy in Moscow advised all American citizens to immediately leave Russia due to the ongoing war in Ukraine, citing the "risk of wrongful detentions".
In U.S., the National Institutes of Health has implemented a major national initiative to leverage existing academic health center infrastructure through the Clinical and Translational Science Awards. The National Center for Advancing Translational Sciences (NCATS) was established on December 23, 2011. Although translational research is relatively new, it is being recognized and embraced globally. Some major centers for translational research include:
Sources: en.wikipedia.org
It separates components in a liquid sample and measures their amounts using a detector. Results can indicate concentration, purity, or identity based on retention time and detector response. The technique works for mixtures that can be dissolved and filtered.
It offers high resolution, reproducibility, and compatibility with many sample types. A single run can separate and quantify multiple analytes. It is common in pharmaceutical, food, environmental, and industrial laboratories.
Samples must be soluble in a suitable mobile phase and free of particles that can block the column. Detector response depends on analyte structure, so some compounds need derivatization or alternative detection. Complex matrices may require extensive sample preparation.
HPLC separates and detects individual compounds in a liquid sample, producing peaks at characteristic retention times. Peak area or height can be used to estimate concentration when calibrated with known standards. It does not identify unknown compounds with certainty unless additional detectors or reference materials are used.