If you have been reading about mobile phase and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2025-12-12. Numbers and descriptions here follow the published literature rather than marketing material.
Method validation establishes that an HPLC procedure is suitable for its intended purpose. Typical parameters include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, robustness, and solution stability. Accuracy reflects closeness to a reference value, while precision reflects agreement among repeated measurements. Specificity shows whether the method can measure the analyte without interference from matrix components. Validation is documented through protocols and reports, and the required extent depends on the method's use and regulatory context.
Routine quality control uses system suitability, blank injections, check standards, and control samples to detect drift or contamination. System suitability criteria may specify minimum resolution, maximum tailing factor, and a permitted range for repeated injections. Blank injections reveal carryover or solvent contamination, while check standards confirm calibration accuracy over a batch. Control samples with known analyte levels can show whether results remain within statistical limits. When a control result falls outside limits, the analyst investigates the cause and may invalidate affected results before repeating the batch.
Developing an HPLC method begins with defining the purpose, such as quantifying a main component, measuring impurities, or confirming identity. Analysts select separation mode, column, mobile phase, detection, and sample preparation based on analyte properties and matrix. Experiments vary solvent strength, pH, buffer type, and temperature to achieve resolution between critical peaks. The goal is a robust method that produces reliable results across instruments and operators. Method development often involves trial runs and statistical optimization.
Validation demonstrates that a method is suitable for its intended use. Typical performance characteristics include accuracy, precision, specificity, linearity, range, limit of detection, limit of quantitation, and robustness. Regulators and standards organizations provide frameworks, but specific requirements depend on the application and jurisdiction. System suitability tests are run before sample analysis to confirm resolution, peak symmetry, retention time repeatability, and sensitivity. A validated method is not permanently fixed; changes may require partial or full revalidation.
| Property | Value | Notes |
|---|---|---|
| Accuracy | Recovery near 100% | Depends on acceptance criteria and matrix |
| Precision | Relative standard deviation | Often at or below 2% for replicate injections |
| Limit of detection | Signal-to-noise ratio 3:1 | Approximate and method-specific |
| Limit of quantitation | Signal-to-noise ratio 10:1 | Confirmed by precision and accuracy |
| Resolution | 1.5 or greater | Typical system suitability target |
Separation modes differ by the chemistry of the stationary phase and the composition of the mobile phase. Reversed-phase testing uses a nonpolar column and polar solvents, making it common for pharmaceutical, environmental, and food analytes. Normal-phase testing uses a polar column and nonpolar solvents for compounds that are poorly retained in reversed-phase systems. Ion-exchange and ion-pair methods separate charged species, while size-exclusion methods sort molecules by hydrodynamic volume. Gradient elution changes solvent strength over time to resolve complex mixtures, and isocratic elution holds solvent composition constant for simpler assays.
Key performance measures include retention time, peak area, peak height, resolution, tailing factor, and plate count. Retention time helps identify a peak under fixed conditions, but confirmation often requires a second method or detector. Peak area and height relate to concentration through calibration curves, which may be linear or nonlinear depending on the detector response. Resolution describes separation between adjacent peaks, while tailing factor and plate count describe peak shape and column efficiency. Performance checks verify these values before and during a run to confirm that the instrument is performing within limits.
HPLC testing separates dissolved compounds by passing a liquid sample through a column packed with stationary phase. A pump delivers mobile phase at controlled flow, and the sample components interact differently with stationary and mobile phases. Compounds that spend more time in mobile phase elute earlier; those retained by stationary phase elute later. Detectors record elution as peaks, and peak area or height relates to amount. This mechanism underpins quantitative analysis of mixtures.
Most routine HPLC testing uses reversed-phase columns, where the stationary phase is nonpolar and the mobile phase is a polar mixture such as water with an organic solvent. Analytes partition between the two phases according to polarity, size, and charge. Gradients that change solvent composition over time can separate compounds with broad retention ranges. Isocratic conditions keep solvent composition constant and suit simpler mixtures. The choice of column chemistry, pH, and temperature affects selectivity and peak shape.
Detection in HPLC testing commonly relies on ultraviolet-visible absorbance, fluorescence, refractive index, or mass spectrometry. UV detection is widely used because many organic compounds absorb light, but it requires a chromophore. Mass spectrometry provides mass-based identification and high sensitivity for trace analytes. Each detector has trade-offs in selectivity, cost, and compatibility with mobile phases. Quantification typically uses calibration curves prepared from reference standards. Results are reported as concentration, purity, or presence above a limit.
== Pathology == Abnormal protein phosphorylation has been implicated in a number of diseases, including cancer, Alzheimer's disease, Parkinson's disease, and other degenerative disorders. Tau protein belongs to a group of microtubule associated proteins (MAPs) which help stabilize microtubules in cells, including neurons. Association and stabilizing activity of tau protein depends on its phosphorylated state. In Alzheimer's disease, due to misfoldings and abnormal conformational changes in tau protein structure, it is rendered ineffective at binding to microtubules and unable to keep the neural cytoskeletal structure organized during neural processes. Abnormal tau inhibits and disrupts microtubule organization and disengages normal tau from microtubules into cytosolic phase. The misfoldings lead to the abnormal aggregation into fibrillary tangles inside the neurons. The tau protein needs to be phosphorylated to function, but hyperphosphorylation of tau protein is one of the major influences on its incapacity to associate. Phosphatases PP1, PP2A, PP2B, and PP2C dephosphorylate tau protein in vitro, and their activities are reduced in areas of the brain in Alzheimer patients. Tau phosphoprotein is three to fourfold hyperphosphorylated in an Alzheimer patient compared to an aged non-afflicted individual. Alzheimer disease tau seems to remove MAP1 and MAP2 (two other major associated proteins) from microtubules and this deleterious effect is reversed when dephosphorylation is performed, evidencing hyperphosphorylation as the sole cause of the crippling activity.
All polyamides are made by the formation of an amide function to link two molecules of monomer together. The monomers can be amides themselves (usually in the form of a cyclic lactam such as caprolactam), α,ω-amino acids or a stoichiometric mixture of a diamine and a diacid. Both these kinds of precursors give a homopolymer. Polyamides are easily copolymerized, and thus many mixtures of monomers are possible which can in turn lead to many copolymers. Additionally many nylon polymers are miscible with one another allowing the creation of blends.
Libya had long supported the FROLINAT militia in neighbouring Chad, but FROLINAT became divided over its ties to Libya in 1976. In January 1978, the anti-Libya faction within FROLINAT, led by Hissène Habré, switched sides and allied with Chadian President Félix Malloum. Meanwhile, the pro-Libya faction within FROLINAT, led by Goukouni Oueddei, renamed itself People's Armed Forces (FAP). In December 1980, Gaddafi reinvaded Chad at the request of the FAP-controlled GUNT government to aid in the civil war; in January 1981, Gaddafi suggested a political merger. The Organisation of African Unity (OAU) rejected this and called for a Libyan withdrawal, which came in November 1981. The civil war resumed, and Libya sent troops back in. In 1982, the GUNT government was overthrown by Habré's forces and Oueddei fled to Libya, where Gaddafi provided him with arms to continue to guerrilla war against Habré. In November 1984, Gaddafi met with French President François Mitterrand; both agreed to withdraw from Chad. Oueddei broke with Gaddafi in 1985 due to the former's intentions to negotiate a truce with Habré. Consequently, he was placed under house arrest by Gaddafi and allegedly arrested by Libyan police and shot in the stomach. Oueddei survived the shooting and fled to Algeria, but continued to claim he and Gaddafi enjoyed a good relationship. When Gaddafi ordered the remnant of GUNT to attack Habré in February 1986 in violation of his agreement with Mitterrand, France launched Operation Épervier, which escalated into the Toyota War.
Sources: en.wikipedia.org
== History == Malacidins were discovered by researchers at Rockefeller University, led by Brad Hover and Sean Brady. The group had been looking into antibiotics related to daptomycin and their calcium-dependent nature, but determined that it would be impractical to culture variations in lab conditions. Instead, the team used a genetics approach that was more scalable. They focused on searching for novel biosynthetic gene clusters (BGCs) – genes that are usually expressed together, that bacteria use to make secondary metabolites. To do this, they extracted DNA from around 2,000 soil samples to build metagenomic libraries that captured the genetic diversity of the environmental microbiome. They then designed degenerate primers to amplify genes likely to be similar to the BGC that make daptomycin by using a polymerase chain reaction (PCR) procedure, sequenced the amplified genes, and then used metagenomics to confirm that these genes were indeed likely to be the kind of BGCs they sought. One of the novel BGCs they found was present in around 19% of the screened soil samples but not readily found in cultured microbial collections, so they took that BGC, put it into other host bacteria, and then isolated and analyzed the secondary metabolites. The work was published in Nature Microbiology in February 2018.
== Medicine and science == Terminal restriction fragments, used in measuring telomere length Thyrotropin-releasing factor, a peptide hormone secreted by the hypothalamus Time-restricted feeding, a type of intermittent fasting Transfer RNA-derived fragment TERF1, Telomeric repeat-binding factor 1 (also known as TRF1)
=== Membership policy === WOSM's membership consists of its remaining founding member organizations and organizations recognized by WOSM as national scout organizations. WOSM's rules protect its founding and existing member organizations by permitting only one member organization in each country and locking-out all other Scout organizations from WOSM membership, recognition and participation no matter how worthy or large their membership. Several member organizations are federations, some with different component groups divided on the basis of religion (e.g., France and Denmark), ethnic identification (e.g., Israel) or language (e.g., Belgium). However, WOSM has never required an existing member organization to federate with other Scout organizations in the country, in order to make WOSM more inclusive and representative. There are numerous Canadian Scout organizations but only one is a WOSM member organization (the Canadian branch of one of the organizations that founded WOSM) which has a French language affiliate which is thereby recognized by WOSM. Other than this inherent limitation on WOSM membership, the basis for WOSM membership includes adherence to WOSM's aims and principles and independence from political involvement on the part of each member organization.
The Monovalent Cation:Proton Antiporter-2 (CPA2) Family (TC# 2.A.37) is a moderately large family of transporters belonging to the CPA superfamily. Members of the CPA2 family have been found in bacteria, archaea and eukaryotes. The proteins of the CPA2 family consist of between 333 and 900 amino acyl residues and exhibit 10-14 transmembrane α-helical spanners (TMSs).
Sources: en.wikipedia.org
=== Technology === When considering food storage and preservation, the technologies of modified atmosphere and controlled atmosphere are widely used for the storage and packing of several types of foods. They offer several advantages such as delay of ripening and senescence of horticultural commodities, control of some biological processes such as rancidity, insects, bacteria and decay, among others. Controlled atmosphere (CA) storage refers to atmospheres that are different than normal air and strictly controlled at all times. This type of storage manipulates the CO2 and O2 levels within airtight stores of containers. Modified atmosphere (MA) storage refers to any atmosphere different from normal air, typically made by mixing CO2, O2, and N2.
Anderson's steam-pressure method of shooting rice from guns created puffed rice and puffed wheat. Crowell's intensive advertising campaign in the 1920s and 1930s featured promotions with such celebrities as Babe Ruth, Max Baer, and Shirley Temple. Sponsorship of the popular Rin-Tin-Tin and Sergeant Preston of the Yukon radio shows aided the company's expansion during the depression. Meat rationing during World War II boosted annual sales to $90 million (equivalent to $1.6 billion today), and by 1956 sales topped $277 million ($3.3 billion today). By 1964 the firm sold over 200 products, grossed over $500 million ($5.2 billion today), and claimed that eight million people ate Quaker Oats each day. Expansion included the acquisition of Aunt Jemima Mills Company in 1926, which continues as a leading brand of pancake mixes and syrup, the sport drink Gatorade in 1983, and in 1986, the Golden Grain Company, producers of Rice-A-Roni canned lunch food. In 2001, Quaker Oats was itself bought out by PepsiCo.
== Related quantities == Molar mass is closely related to the molecular weight (M.W.) (for molecular compounds) and formula weight (F.W.) (for non-molecular compounds), older terms for what is now more correctly called the relative molar mass (Mr), a dimensionless quantity (i.e., a pure number, without units) equal to the molar mass divided by the molar mass constant, calculated from the standard atomic weights of its constituent elements. However, it should be distinguished from the molecular mass (which is confusingly also sometimes known as molecular weight), which is the mass of one molecule (of any single isotopic composition), and to the atomic mass, which is the mass of one atom (of any single isotope). The dalton, symbol Da, is also sometimes used as a unit of molecular weight and formula weight (now called relative molar mass), especially in biochemistry, despite the fact that the quantities are dimensionless as relative masses. Obsolete terms for molar mass include gram atomic mass for the mass, in grams, of one mole of atoms of an element, and gram molecular mass for the mass, in grams, of one mole of molecules of a compound. The gram-atom is a former term for a mole of atoms, and gram-molecule for a mole of molecules.
Sources: en.wikipedia.org
Validation establishes suitability for a new method, while verification confirms that a method works in a specific laboratory. Verification is often used when a validated method is adopted with existing equipment and staff. Both rely on documented acceptance criteria.
Quantification usually compares detector response to a standard curve made from reference standards. The curve may be external, internal, or based on standard addition depending on matrix effects. Results are reported with units and, when required, uncertainty.
Carryover occurs when analyte from a previous injection remains in the system and appears in a later chromatogram. It can come from the injector, column, or tubing. Blank injections and needle washes help detect and reduce it.
It is a set of checks performed before or during an HPLC run to confirm the system works as expected. Parameters may include resolution, tailing factor, theoretical plates, and retention time precision. Failure can trigger maintenance, method adjustment, or repeat analysis.